Monitored Dump Single Valve ISO

New

£164.36

- +

Starting from a series of sturdy, reliable valves, such as those to ISO 5599/1, some special features have been added, such as the presence of a valve status diagnostic system and the creation of a double channel guaranteeing architecture redundancy.

The simplest version features one electropneumatically-operated 5/2monostable valve. It is common knowledge that when this type of valve is in the idle state (coil not energized), port 1 is connected to port 2, and port 4 relieves. When the valve is operated (coil energized), port 1 is connected to port 4, and port 2 relieves. When the coil is de-energized again, the valve is returned to the idle state (so port 4 relieves) by means of a spring that returns the spool to the home position. In the event of a failure, the spool may remain in the actuating position, even with coil de-energized, leaving port 4 pressurized. 

To offset this problem, we have added a Hall-effect sensor that reads the spool position. This means that when the valve is deactivated, the sensor is on, and when the valve is activated, the sensor is off. A status in which the sensor is off and the coil de-energized indicates a problem.

To reduce the probability of risk during plant maintenance, the manual actuator mounted on the Cnomo electric control is the monostable type. 

The sensor inside the valve is available in the standard version with a 2.5m three-wire cable (standard or ATEX certified) or with an M8 connector and a 300 mm cable.

This valve, which is available in 3 sizes for the ISO 5599/1 series, is a category 2 component according to ISO EN 13849 and is suitable for use in safety circuits up to PL=c.

No customer comments for the moment.

Write a review

Monitored Dump Single Valve ISO

Monitored Dump Single Valve ISO

Related Products

ISO1 Sub Base Side Ported 1/4BSP

£14.25

Product Weight: 0.3kg Effective Sectional Area (mm2) IN-OUT: 70 OUT-EXHAUST: 50

£31.85

Complies with EN983 - 5.3.4.3.2. and ISO 4414 - 5.4.5.11.1

£27.42

Manufactured from chemical and impact resistant acetal resin.

£12.27

- Robust and compact design - Extensive, easy to fit with additional nozzle range  

£16.51

Low noise Safety blowgun meets OSHA standard

£23.47

Safety Aircurtain blowgun with increased air flow and low noise level (meets OSHA standard). This blowgun is equipped with a flat safety nozzle, which not only meets requirements on noise and safety, it also provides extremely high blowing force.  

£15.64

A comprehensive range of threaded (1/8" inlet), easy to fit, interchangeable nozzles to cater for all blowgun applications.

£2.87

2 bar automatic pressure reduction, low noise level (meets OSHA standard) Conforms to HSE requirements. Air inlet automatically reduced to 2 bar.

£50.40

TURBO nozzle safety blowgun increases air flow by 100%

£25.17

Removes oil mist from exhaust airs Efficiently silences exhaust air Improves working conditions

£90.76

REG 200 KEY  8 BAR

£51.91

Slow Start Valve with Silencer and "DIN" plug connection  

£176.67